Swage Rigging Toggle For 1/8" Cable - Type 316 Stainless Steel
Swage Rigging Toggle For 1/8" Cable - Type 316 Stainless Steel
  • Load image into Gallery viewer, Swage Rigging Toggle For 1/8" Cable - Type 316 Stainless Steel
  • Load image into Gallery viewer, Swage Rigging Toggle For 1/8" Cable - Type 316 Stainless Steel

Swage Rigging Toggle For 1/8" Cable - Type 316 Stainless Steel

Vendor
DEVLINERAIL
Regular price
$4.88
Sale price
$4.88
Regular price
$0.00
Sold out
Unit price
per 

Swage Rigging Toggle for 1/8″ Cable – Type 316 Stainless Steel

If you’re on the hunt for a swage rigging toggle that can be used on straight or angled runs, here we have a great option for you. Made with T316 stainless steel, you’re able to install them down in humid climates or up in the mountains with all 4 seasons. Stainless won’t rust being outdoors and if you see build-up accumulate over time, using a steel cleaner will shine them right up.

With swage fittings like this, you are going to need a hand swaging tool. After you slide cable into the fitting, it’s recommended to swage each one 3 times for a good hold. A real cable cutter tool will also be needed during the install. Failing to use a cutter meant for wire rope could leave you with flattened ends and that makes sliding cable into fittings difficult.

Be sure you also get the right steel wire cable for the job as well. These fittings were made for 1/8″ steel cable. There are a number of different configuration options available but if you’re doing a cable railing we’d suggest 1×19. It gives off a nice even shine during the day or under the lights at night. You’ll also be able to grab the cable with your hand without it being too rough.

 

Specifications of Rigging Toggle

– This fitting is a total of 3″ long

– Use with 1/8″ stainless steel cable (we suggest 1×19 configuration)

– Is the anchor end of a run, you’ll need a tensioner fitting on the opposite end

– Made with type 316 steel

– Installed inside and out